Pneumatic Pre-Notch/Cut-Off Roll Forming Press
From small 5-ton to large 100-ton capacity,
we build them all. Our advanced engineering gives every
model accuracy, strength, dependability, design, and
construction to withstand the constant stroking required of
today's high-speed automatic
Roll
Forming, and metal-working operations. We build
pneumatic (air) Presses
used for Cut-off,
pre-notch, piercing, and embossing.
From the beginning to the end of your Roll Forming line, it
pays to make
Roll-Kraft
your source for completely integrated metal processing
equipment. Our equipment is designed to last. This means
lower long-term costs, improved productivity, and increased
profits.
Typical Applications:
Standard Features:
-
Normal shop air supply provides ample
power (110-volt electrical supply needed
to energize controls only)
-
Independently adjustable length of
stroke and speed of stroke
-
Adjustable tonnage – governed by piston
diameter, air pressure regulator
setting, stroke length, and velocity
-
Infinitely adjustable shut height –
completely independent of stroke
adjustment
-
Precision alignment - guaranteed with 2-
or 4-post die set principle
|
|
Maintenance
Features:
-
Low maintenance
-
High speed
-
Trouble-free operation
|
|
The only routine maintenance on
this
Pneumatic Press is the O-ring
replacement. Die changes are fast and easy to make. This
low-maintenance pneumatic press increases high-speed
production without employing a motor, crankshaft, clutch, or
V-belt.
Optional Features: Solid
steel bases with adjustable sub-plates Oversize beds
Tilt-type bases Die return system Die accelerator PC
solid-state programmable press controls
roll forming presses,
|
|
|
