Tube and Pipe
Central Lube System
Tube and Pipe Central lube systems are an excellent
investment when it comes to maintaining your rolling mill
(or other machine component) and protecting your investment.
These systems can automatically lubricate all of the lube
points on the machine while it is running production.
Central lube system for weld rolls
- The unit is
completely separate from the main system
because weld rolls need more
lubrication, more often than the rest of
the mill.
-
A one pound reservoir
is included which can last up to 150
eight-hour shifts.
-
Each injector is
equipped with a failsafe indicator that
notifies you if a bearing does not take
grease.
-
Each unit is equipped
with a timer, which is adjustable for
the number of cycles per hour and is
wired into the run circuit of the mill.
If the mill isn’t running, the mill
doesn’t get greased.
|
Central system for the
breakdown, fin, and sizing sections
-
Unit
incorporates
a four pound reservoir that can last up
to 85 eight-hour shifts.
|
Large remote panel to serve the
breakdown and fin sections
-
A smaller unit serves the sizing
section.
-
They are remotely located to prevent
damage.
|
System is built in modular
units for easy installation
-
Each injector panel has quick-connect
fittings.
-
Simply cut the desired length of plastic
feed line and push in the fitting.
-
There are no expensive hoses or lines to
replace.
-
Plastic line is very durable, high
pressure rated and very inexpensive to
replace.
-
The average time to replace a broken or
damaged line is 20 seconds.
|
|
|
|
